RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

VK4ZZ-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK4ZZ-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1735054187	160	172	214	232	168
1735050585	160	172	212	228	169
1735036160	161	188	220	218	168
1735035095	161	188	214	216	157
1735034777	161	189	223	242	170
1735034766	161	189	222	227	167
1735034606	161	189	219	235	177
1735031978	161	172	215	231	172
1735028377	162	172	97	110	77
1735024769	162	173	215	225	167
1735021168	163	174	220	236	178
1735017566	163	188	213	224	159
1735017301	163	188	213	209	152
1735016307	162	188	223	241	173
1735015854	162	188	223	234	175
1735015810	162	189	224	243	173
1735015789	162	187	213	229	169
1735014898	162	189	222	227	158
1735014588	162	190	227	232	171
1735014579	162	189	221	225	141
1735005702	161	189	222	227	156
1735005508	161	189	222	227	167
1735005334	161	190	216	213	162
1735002553	161	169	199	210	134
1735000002	161	169	205	234	176

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)