RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

N7SHM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N7SHM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734967546	142	71	999	676	514
1734965746	141	72	999	675	511
1734963946	141	72	999	673	508
1734962147	141	72	999	675	510
1734960349	141	72	999	678	516
1734958547	142	71	999	677	514
1734956748	142	71	999	674	510
1734954950	141	72	999	675	510
1734953152	141	72	999	680	519
1734951354	142	72	999	679	518
1734949556	141	73	999	675	511
1734947758	141	72	999	680	518
1734945960	141	72	999	678	517
1734944162	141	72	999	677	515
1734942364	142	72	999	673	508
1734940566	141	72	999	678	515
1734938768	141	72	999	674	510
1734936969	141	72	999	674	509
1734929777	142	72	999	676	511
1734927979	141	72	999	680	518
1734926180	141	72	999	676	511
1734924382	141	72	999	676	513
1734922584	142	72	999	676	512
1734920786	141	73	999	678	516
1734918987	141	73	999	674	509

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)