RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

ALDER Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ALDER. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734902268	213	47	32	23	119
1734901968	214	47	32	23	119
1734901668	214	47	32	23	119
1734901368	209	47	32	23	119
1734901068	211	47	32	23	119
1734900768	210	47	32	23	119
1734900469	210	47	32	23	119
1734900168	208	47	32	23	119
1734899871	208	47	32	23	119
1734899568	209	47	32	23	119
1734899269	200	47	32	23	119
1734898968	215	47	32	23	119
1734898784	210	47	32	23	119
1734898070	210	47	32	23	119
1734897468	217	47	32	23	119
1734897168	217	47	32	23	119
1734896868	216	47	32	23	119
1734896568	217	47	32	23	119
1734896268	210	47	32	23	119
1734895968	217	47	32	23	119
1734895668	214	47	32	23	119
1734895368	217	47	32	23	119
1734895071	216	47	32	23	119
1734894469	214	47	32	23	119
1734894169	211	47	32	23	117

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)