RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

VE6AMC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE6AMC. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734886828	114	113	145	66	47
1734885028	115	113	145	66	47
1734884134	114	113	145	66	45
1734881428	115	113	145	66	46
1734879628	115	21	145	66	46
1734876934	116	0	145	66	42
1734874228	116	0	145	66	42
1734871528	116	0	145	66	42
1734869733	117	0	145	66	42
1734868827	117	0	145	66	42
1734867027	117	0	145	66	42
1734865227	119	0	145	66	42
1734864327	119	0	145	66	42
1734863427	118	0	145	66	42
1734861627	118	0	145	66	42
1734859827	118	0	145	66	43
1734858933	117	0	145	66	42
1734857127	118	0	145	66	43
1734854427	117	0	145	66	43
1734851732	118	0	145	66	43
1734849027	118	0	145	66	43
1734848133	117	0	145	66	43
1734841826	117	0	144	66	43
1734840026	117	0	145	66	43
1734837332	119	0	145	66	42

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)