RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

ACARC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ACARC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734939783	139	156	255	97	96
1734936180	139	156	255	97	96
1734928973	139	156	255	96	96
1734925370	139	156	255	96	96
1734921768	139	156	255	96	95
1734918163	139	156	255	95	94
1734914560	132	157	255	94	92
1734910956	139	157	255	93	91
1734907353	139	159	255	90	86
1734903750	139	159	255	90	86
1734900147	133	158	255	91	88
1734896545	139	158	255	93	90
1734892942	139	155	255	98	97
1734889336	139	155	255	99	98
1734885734	139	155	255	99	99
1734882131	139	154	255	100	100
1734878528	139	154	255	99	100
1734874925	139	154	255	99	99
1734871323	139	154	255	99	99
1734867719	139	154	255	99	99
1734864116	139	154	255	99	99
1734860514	139	154	255	99	99
1734856911	139	154	255	99	99

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)