RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

ZL2PO-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL2PO-8. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734949901	132	128	255	62	46
1734948700	132	128	255	62	46
1734947499	132	129	255	61	45
1734946298	132	130	255	61	45
1734945097	132	131	255	60	44
1734943896	132	131	255	60	44
1734942695	132	132	255	60	43
1734941494	131	132	255	59	43
1734940293	132	133	255	58	42
1734939092	132	133	255	58	42
1734937891	132	134	255	58	41
1734936690	132	134	255	57	41
1734929484	134	137	255	56	39
1734928283	134	137	255	55	39
1734927081	134	138	255	55	39
1734925881	134	138	255	55	39
1734923478	134	137	255	56	39
1734922278	134	136	255	56	40
1734921076	134	136	255	57	42
1734919875	135	135	255	57	42
1734918674	134	135	255	57	43
1734917474	134	135	255	57	41
1734916273	134	134	255	57	41
1734915071	134	134	255	57	41
1734913870	135	134	255	58	41

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)