RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

KQ6DI-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	DC*	PC Board*	Ambient*	upper*	lower*
1734921063	266	803	697	589	586
1734920466	269	804	698	594	590
1734919865	269	805	699	604	596
1734919263	269	798	695	596	591
1734918666	269	800	696	598	592
1734918066	266	800	696	605	596
1734917463	266	803	696	607	600
1734916865	269	802	698	611	604
1734916266	266	803	697	617	608
1734915663	269	804	696	626	612
1734915066	269	805	696	634	619
1734914465	268	804	697	645	628
1734913863	268	805	698	655	638
1734913266	269	806	698	663	651
1734912666	268	807	699	672	658
1734912063	268	807	700	689	665
1734911465	273	802	696	689	661
1734910866	271	802	695	697	665
1734910263	273	802	696	701	669
1734909666	273	803	696	716	678
1734909066	273	803	696	728	687
1734908463	280	803	697	744	699
1734907866	281	803	696	758	710
1734907266	283	804	697	766	718
1734906663	288	804	697	773	722

*Used Equation Coefficients:

DC: 0, 1, 0

PC Board: 0, 1, 0

Ambient: 0, 1, 0

upper: 0, 1, 0

lower: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)