RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

XE1AU-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE1AU-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734941289	126	38	999	393	297
1734937737	127	37	999	393	297
1734927080	127	39	999	390	293
1734923528	128	40	999	385	288
1734919976	128	42	999	382	285
1734916424	129	44	999	377	279
1734912872	147	50	999	360	262
1734909319	135	49	999	363	264
1734905768	141	53	999	355	255
1734902215	149	52	999	356	257
1734895110	146	53	999	354	254
1734891558	148	48	999	366	268
1734888006	149	46	999	371	273
1734884454	125	41	999	383	286
1734880902	127	40	999	386	289
1734877350	125	39	999	389	293
1734873798	123	39	999	390	293
1734870246	123	39	999	389	292
1734866694	124	39	999	390	293
1734863142	124	39	999	391	294
1734859589	125	39	999	390	294

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)