RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

PY5CTV-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5CTV-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734984173	138	204	179	141	141
1734983872	138	205	181	141	141
1734983571	138	206	181	141	142
1734983268	138	210	183	141	141
1734982967	138	208	181	141	141
1734982665	138	208	182	141	141
1734982351	138	207	183	141	142
1734982049	138	210	184	141	141
1734981748	138	209	186	141	142
1734981448	138	209	185	141	142
1734981145	138	204	180	141	142
1734980845	138	204	181	141	141
1734980544	137	205	182	141	141
1734980243	138	205	183	141	141
1734979943	138	205	182	141	142
1734979637	138	200	176	141	142
1734979337	138	202	179	141	142
1734979036	138	205	180	141	141
1734978736	138	201	177	141	142
1734978430	138	202	178	141	142
1734978129	138	203	181	141	142
1734977828	138	208	185	141	141
1734977515	138	206	183	141	142
1734977213	138	207	184	141	142
1734976912	138	208	185	141	142

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)