RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

ZL1UHF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL1UHF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*
1734955407	147	158	14	26
1734954506	147	158	15	26
1734953604	147	158	14	26
1734952703	147	158	15	26
1734951801	148	158	15	26
1734950900	148	158	15	26
1734949998	148	158	14	26
1734949097	148	158	14	26
1734948195	148	158	15	26
1734947294	148	159	15	26
1734946392	148	158	14	26
1734945491	148	158	15	26
1734944589	148	159	15	26
1734943688	148	159	15	26
1734942786	148	159	14	26
1734941885	148	158	15	26
1734940983	148	159	27	26
1734940082	148	159	87	26
1734939180	149	159	138	26
1734938279	148	159	157	26
1734937377	149	161	159	26
1734936476	149	163	160	26
1734930175	150	181	232	26
1734929274	150	181	234	26
1734928372	150	181	232	26

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)