RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

W1FN-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W1FN-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734929611	129	21	141	134	142
1734927812	129	21	141	134	142
1734924211	117	24	140	133	141
1734922414	128	23	140	133	141
1734913408	130	25	141	133	140
1734906210	130	29	140	131	139
1734904410	130	32	140	131	137
1734897348	132	42	139	127	132
1734889908	132	46	138	126	130
1734888110	132	46	139	127	131
1734886312	135	46	139	126	130
1734884514	140	45	139	126	130
1734882716	141	40	139	128	133
1734880918	139	37	139	129	135
1734879120	139	34	140	130	136
1734872333	62	18	135	129	132
1734871165	130	18	141	135	142
1734869364	128	18	141	135	142
1734867564	128	18	141	135	142
1734865765	128	18	141	135	142
1734863964	128	19	141	135	142
1734862165	128	20	141	135	142
1734860363	128	20	141	134	142
1734858564	128	21	141	134	142
1734856764	128	21	141	134	142

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)