RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

TWOSIS Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TWOSIS. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734917137	122	0	137	126	133
1734913542	124	0	137	126	133
1734909947	123	0	137	126	133
1734906352	124	0	137	125	132
1734902758	124	0	137	125	132
1734899162	125	0	137	125	132
1734895567	127	0	137	125	131
1734891972	130	0	137	125	131
1734888377	123	0	137	125	132
1734884777	124	0	137	126	133
1734881182	126	0	137	125	132
1734877588	124	0	137	125	132
1734873992	126	0	137	125	132
1734870397	124	0	137	125	131
1734866803	124	0	137	124	131
1734863207	126	0	137	124	131
1734859612	127	0	137	124	131
1734852422	118	0	137	124	130
1734848826	120	1	137	124	130
1734845231	122	1	137	123	129
1734841636	126	1	137	123	129
1734838041	122	2	137	123	129
1734834447	123	2	137	123	129

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)