RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

VE2SBR-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE2SBR-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734964595	175	144	46	133	255
1734962794	175	141	45	133	255
1734961000	175	195	45	133	255
1734959195	176	134	45	133	255
1734957392	176	119	43	134	255
1734955594	175	194	43	134	255
1734953792	175	194	45	134	255
1734951993	175	195	44	133	255
1734950194	175	148	46	133	255
1734948396	175	191	43	134	255
1734946595	175	137	45	133	255
1734944795	176	139	45	134	255
1734942995	175	152	46	133	255
1734941194	175	129	45	133	255
1734939397	175	133	45	133	255
1734937593	175	167	45	133	255
1734930395	175	147	45	134	255
1734928598	175	144	45	133	255
1734926797	175	141	46	133	255
1734925000	175	196	45	133	255
1734921393	175	197	48	133	255
1734919595	176	130	45	133	255
1734917793	175	130	45	134	255
1734916008	176	195	45	134	255
1734914196	175	173	46	133	255

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)