RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

QUAIL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object QUAIL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734930273	126	26	75	41	48
1734929653	126	23	76	41	48
1734929032	126	26	77	41	48
1734928410	126	44	75	41	48
1734927789	126	27	74	41	48
1734927165	126	26	76	41	48
1734926546	126	27	78	41	48
1734925923	126	41	77	41	48
1734925304	127	27	76	41	48
1734924687	127	26	80	41	48
1734924069	127	30	75	41	48
1734922830	127	37	76	41	48
1734922210	126	26	75	41	48
1734921590	127	25	77	41	48
1734920970	127	44	74	41	48
1734920351	127	26	93	41	77
1734919730	127	40	75	41	48
1734919106	127	29	74	41	48
1734918488	127	29	77	59	48
1734917869	127	30	76	41	48
1734917247	127	27	77	41	48
1734916625	127	25	75	41	48
1734916000	128	26	74	41	48
1734915381	127	28	71	41	48
1734914760	128	31	74	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)