RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

BVILLE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object BVILLE. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734939326	125	26	77	41	48
1734938723	126	25	77	66	49
1734938123	126	29	77	41	48
1734937522	126	28	77	41	49
1734936920	126	25	77	66	49
1734936319	126	25	77	41	48
1734930302	126	26	106	41	48
1734929698	126	59	77	41	48
1734929095	126	51	77	41	49
1734928494	126	69	77	41	48
1734927285	126	25	76	41	48
1734926081	126	29	76	41	48
1734925479	126	32	77	66	49
1734924878	126	72	76	81	49
1734924276	126	27	107	42	76
1734923673	126	29	76	41	48
1734923071	127	26	76	66	49
1734922468	127	29	76	41	48
1734921867	127	55	75	41	49
1734921265	127	27	77	41	48
1734920664	127	44	76	41	48
1734920062	126	25	76	41	48
1734919457	127	48	108	42	77
1734918854	126	26	77	41	48
1734918250	127	29	77	41	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)