RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

W8ALC Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W8ALC. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734938367	255	97	75	71	72
1734937165	255	97	75	71	72
1734936387	255	97	75	71	72
1734929947	255	97	74	71	72
1734928746	255	97	74	71	72
1734927542	255	97	74	71	72
1734926339	255	97	74	71	72
1734925136	255	97	74	71	72
1734923935	255	97	74	71	72
1734922733	255	96	74	71	72
1734921532	255	96	74	71	72
1734920329	255	96	74	71	72
1734919126	255	97	74	71	72
1734917924	255	97	74	71	72
1734916723	255	96	74	71	72
1734915522	255	96	74	71	72
1734914321	255	96	74	71	72
1734913120	255	96	74	71	71
1734911918	255	96	74	71	72
1734910717	255	96	74	70	71
1734909513	255	96	74	70	71
1734908311	255	96	74	70	72
1734907109	255	96	74	70	71
1734905908	255	96	73	70	71
1734904707	255	96	73	71	71

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)