RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

VK4RBW-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK4RBW-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734918321	137	255	179	143	119
1734914719	136	255	178	142	119
1734911118	136	255	178	142	119
1734907514	136	255	178	142	119
1734903912	136	255	178	142	119
1734900310	137	255	178	143	117
1734896709	136	255	178	142	119
1734893105	128	255	179	143	120
1734889501	136	255	179	143	117
1734885899	137	255	179	143	117
1734882298	136	255	179	143	117
1734878692	136	255	178	142	117
1734875091	137	255	178	143	118
1734871490	128	255	179	143	118
1734867886	128	255	178	143	118
1734864280	137	255	178	142	119
1734860678	137	255	178	142	119
1734857076	136	255	178	143	119
1734853472	137	255	178	142	119
1734849868	137	255	178	142	119
1734846265	137	255	178	143	117
1734842662	137	255	179	143	117
1734839060	136	255	178	142	119
1734835458	136	255	179	143	117

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)