RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

DG8AAC-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG8AAC-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734962263	153	191	227	233	180
1734962212	153	187	221	239	189
1734962144	153	191	229	233	181
1734962066	153	186	212	221	175
1734962021	153	187	221	225	168
1734959727	153	191	227	219	169
1734959676	153	191	227	219	171
1734959651	153	189	224	211	151
1734952335	153	164	201	227	153
1734950350	153	165	208	221	179
1734950310	153	169	212	221	175
1734950269	153	161	205	233	179
1734946935	151	165	208	207	175
1734946841	151	165	209	228	167
1734946577	151	164	201	215	171
1734946281	150	163	209	227	171
1734946230	150	165	208	221	177
1734946195	150	188	217	233	181
1734946139	149	189	224	227	173
1734946093	149	189	225	233	177
1734946063	149	189	225	233	179
1734920406	149	167	203	215	162

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)