RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

NR0Q-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NR0Q-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1736461883	147	36	999	361	285
1736461702	146	35	999	365	289
1736461519	146	33	999	369	294
1736461336	147	32	999	373	298
1736461155	147	30	999	376	303
1736460972	145	27	999	381	308
1736460787	146	25	999	387	314
1736460608	144	22	999	394	323
1736460417	132	17	999	278	176
1736460311	144	13	999	415	347
1736460130	132	0	999	259	151
1736427715	145	25	999	384	312
1736427530	146	24	999	388	315
1736427349	145	23	999	391	319
1736427168	146	21	999	394	323
1736426987	145	19	999	398	328
1736426806	145	17	999	403	335
1736426625	146	13	999	411	343
1736426440	133	8	999	311	217
1736426391	146	5	999	430	363
1736426210	130	0	999	252	144
1736379276	146	66	999	295	201
1736379095	145	65	999	298	203
1736378913	145	64	999	300	207
1736378732	146	62	999	304	212

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)