RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

IZ1DNG Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ1DNG. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1735060340	146	211	226	234	166
1735060264	145	210	225	227	164
1735060254	145	210	225	224	169
1735060222	144	210	219	223	169
1735060181	144	136	134	130	139
1735056822	147	211	225	222	166
1735056801	147	211	225	234	168
1735056764	147	211	225	220	164
1735056734	147	211	217	215	164
1735056727	147	211	218	239	169
1735056632	147	211	225	220	163
1735056611	147	211	225	227	160
1735056461	146	211	225	224	168
1735056379	145	211	225	235	171
1735055274	146	211	225	220	162
1735055261	145	210	225	230	164
1735055184	145	212	225	226	162
1735055164	145	211	229	237	177
1735055120	145	138	137	134	142
1735053240	146	211	225	216	165
1735053207	146	212	225	227	165
1735053155	146	211	225	221	172
1735053150	146	212	226	237	171
1735052931	145	165	144	126	149
1734982439	146	213	226	223	169

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)