RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

KF6NMZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF6NMZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734949229	123	130	255	57	33
1734949106	123	130	255	58	33
1734948740	123	130	255	57	33
1734948619	123	130	255	57	33
1734948498	123	130	255	57	33
1734948256	123	130	255	57	32
1734948220	123	131	255	57	32
1734948131	123	130	255	57	32
1734948009	123	131	255	57	32
1734947888	123	131	255	57	32
1734947766	123	131	255	57	32
1734947643	123	131	255	57	32
1734947522	123	131	255	57	32
1734947400	123	131	255	57	32
1734947278	123	131	255	57	32
1734947156	123	131	255	57	32
1734947035	123	131	255	57	32
1734946912	123	131	255	57	32
1734946790	123	131	255	57	32
1734946424	123	131	255	57	32
1734946303	123	131	255	57	32
1734946059	123	131	255	57	32
1734945943	123	131	255	57	32
1734945816	123	131	255	57	32
1734945571	123	132	255	56	31

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)