RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

NE9DX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NE9DX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734904398	139	150	255	110	87
1734903496	139	150	255	110	87
1734902595	139	150	255	110	87
1734901693	139	150	255	110	87
1734900792	139	150	255	110	87
1734899890	139	150	255	110	87
1734898989	139	150	255	110	87
1734898087	139	150	255	111	87
1734897185	139	150	255	111	87
1734896284	139	150	255	111	87
1734895382	139	150	255	111	87
1734894481	139	150	255	111	88
1734893579	139	150	255	111	88
1734892678	139	150	255	111	88
1734891776	139	150	255	111	88
1734890875	139	150	255	112	88
1734889973	139	150	255	112	88
1734889071	139	150	255	112	88
1734888170	139	150	255	112	88
1734887264	139	150	255	112	88
1734886363	139	149	255	112	88
1734885461	139	149	255	112	88
1734884560	139	149	255	112	89
1734883658	139	149	255	112	89
1734882757	139	149	255	112	89

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)