RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

KB5SQG-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KB5SQG-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1736489679	133	91	255	184	137
1736488779	133	91	255	183	137
1736484283	133	91	255	183	137
1736483383	133	91	255	183	137
1736482484	133	91	255	183	137
1736477088	133	91	255	183	137
1736476188	133	91	255	183	137
1736475288	133	91	255	183	137
1736471691	133	90	255	184	138
1736470791	133	90	255	183	137
1736468093	133	90	255	183	137
1736466295	133	90	255	183	137
1736465396	133	90	255	183	137
1736462697	133	90	255	183	137
1736460899	133	90	255	183	137
1736458200	133	90	255	183	137
1736456402	133	90	255	183	137
1736453704	133	90	255	184	137
1736452804	133	90	255	183	137
1736451905	133	91	255	183	137
1736451006	133	91	255	183	137
1736449206	133	91	255	183	137
1736448307	133	91	255	183	137
1736447408	133	91	255	183	136
1736446508	133	91	255	183	137

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)