RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

VK2WIR-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK2WIR-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734970613	125	19	127	107	96
1734969773	125	18	129	109	98
1734969154	125	19	127	107	96
1734967473	125	19	127	107	95
1734966631	125	19	127	107	95
1734965791	125	19	127	107	95
1734964950	125	19	127	107	95
1734964109	125	19	127	107	95
1734963268	125	19	127	107	96
1734962427	125	19	127	107	96
1734961585	125	19	127	107	95
1734960745	125	19	127	107	95
1734959904	125	19	127	107	95
1734959063	126	19	127	107	95
1734958222	125	20	127	107	95
1734957381	125	20	127	106	95
1734956540	125	20	127	106	95
1734955699	125	20	127	106	95
1734954858	126	20	127	106	94
1734954016	125	21	127	106	94
1734953175	125	21	127	106	94
1734952335	125	21	127	106	94
1734951494	125	22	127	105	94
1734950653	126	22	127	105	93
1734949812	126	22	127	105	93

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)