RADIOCULT.SU - APRS Track Direct

My position About ☰

reset

JR2YQN-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JR2YQN-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1734938717	130	66	255	182	142
1734929617	130	91	255	174	132
1734927816	130	91	255	174	132
1734927755	130	91	255	174	132
1734925955	130	89	255	174	132
1734924157	130	88	255	175	133
1734924101	130	88	255	175	134
1734922303	130	87	255	175	133
1734920454	130	84	255	177	135
1734918658	130	81	255	177	136
1734916857	130	75	255	179	138
1734916826	130	75	255	180	139
1734915028	130	66	255	181	142
1734913225	130	57	255	184	146
1734913204	130	57	255	184	146
1734911405	129	51	255	185	147
1734909606	130	48	255	186	149
1734909591	130	48	255	186	148
1734907793	129	48	255	186	148
1734905995	130	47	255	187	149
1734905981	130	48	255	186	149
1734904182	129	48	255	186	149
1734902388	130	48	255	187	149
1734902373	129	48	255	187	149
1734896959	129	49	255	186	148

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)